Range Rover Evoque: Stability control
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Stability control
- Dynamic stability control (DSC)
- Dsc warning lamp
- Disabling dsc
- Re-enabling dsc
- Electronic traction control (ETC)
- Adaptive dynamics
READ NEXT:
Dynamic stability control (DSC)
DSC is automatically enabled each time the
engine is started, and is automatically enabled
by some of the Terrain response special
programs.
The vehicle is not designed
for
cornering at the sa
Dsc warning lamp
The amber DSC warning lamp in
the instrument panel illuminates
briefly when the ignition is
switched on and extinguishes when the engine
is started.
If the lamp flashes while driving, the DSC
Disabling dsc
Safety may be reduced by
inappropriately disabling DSC. In the
majority of driving situations, and
particularly on-road, it is
recommended that you do not disable
DSC.
In some driving condition
SEE MORE:
Shock Absorber and Spring Assembly Vehicles Without:
Dynamic Suspension
Special Tool(s)
JLR-204-804
Lever, Wheel Knuckle
General Equipment
Transmission jack
Wooden Block
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspension.
LH illustration shown, RH is similar.
NOTES:
Removal steps in this procedure may contain installation d
Condenser TD4 2.2L Diesel
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Disconnect the battery ground cable.
Refer t
© 2011-2025 Copyright www.rrevoque.org
