Range Rover Evoque: Jacking and Lifting
READ NEXT:
General
WARNING: The
following instructions must be adhered to before raising the vehicle off the
ground:
Position vehicle on a solid, level surface.
Apply the parking brake.
Select 'P' - PARK
Two-Post Lift
WARNING:
Make sure that the vehicle is stable before commencing work.
CAUTION: If
the drive shaft(s) are to be removed, release the parking brake and select
NEUTRAL 'N' in the
trans
Towing Points
CAUTION: The
single towing points at the front and rear of the vehicle are designed for
vehicle recovery purposes
only and must NOT be used to tow a trailer or caravan.
The front to
SEE MORE:
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the LH rear wheel and tire.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and
Installati
Removal
NOTES:
It is necessary to remove the inner quarter panel to enable removal and
installation of the rear wheelhouse outer.
The rear wheelhouse outer is manufactured from mild steel.
This method describes the LH rear wheelhouse outer, the RH side is similar.
1. The rear wheelhouse outer is
© 2011-2025 Copyright www.rrevoque.org
