Range Rover Evoque manuals

Range Rover Evoque: Rear Door Trim Panel

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Body and Paint / Interior Trim and Ornamentation / Rear Door Trim Panel

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Torque: 1.3 Nm

Range Rover Evoque. Interior Trim and Ornamentation

2. Torque: 6 Nm

Range Rover Evoque. Interior Trim and Ornamentation

3. Torque: 6 Nm

Range Rover Evoque. Interior Trim and Ornamentation

4.

Range Rover Evoque. Interior Trim and Ornamentation

5.

Range Rover Evoque. Interior Trim and Ornamentation

6.

Range Rover Evoque. Interior Trim and Ornamentation

7. NOTE: Do not disassemble further if the component is removed for access only.

Range Rover Evoque. Interior Trim and Ornamentation

8. Torque: 0.6 Nm

Range Rover Evoque. Interior Trim and Ornamentation

9.

Range Rover Evoque. Interior Trim and Ornamentation

10. Torque: 1 Nm

Range Rover Evoque. Interior Trim and Ornamentation

11.

Range Rover Evoque. Interior Trim and Ornamentation

Installation

1. To install, reverse the removal procedure.

Liftgate Trim Panel

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. NOTE: Make sure the two metal clips are removed from the liftgate.

Range Rover Evoque. Interior Trim and Ornamentation

3. NOTE: Do not disassemble further if the component is removed for access only.

Range Rover Evoque. Interior Trim and Ornamentation

Installation

1. To install, reverse the removal procedure.

READ NEXT:

 Headliner

Removal NOTES: Removal steps in this procedure may contain installation details. Vehicles with glass roof panel shown, vehicles without glass roof panel similar. All vehicles 1. Refer to: Windshield

 Engine Cover GTDi 2.0L Petrol, Engine Cover TD4 2.2L Diesel

Engine Cover GTDi 2.0L Petrol Removal NOTE: Removal steps in this procedure may contain installation details. 1. 2. NOTE: Do not disassemble further if the component is removed for access only. Inst

 Loadspace Trim Panel

CAUTION: LH illustration shown, RH is similar. NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. 2. 3. 4. Torque: 1.4 Nm 5. Torque: 20 Nm 6. NOTE: LH side o

SEE MORE:

 Engine Emission Control - GTDi 2.0L Petrol

Emission Control - Component Location COMPONENT LOCATION Intake manifold Bolt (8 off) Crankcase ventilation hose Oil separator Gasket Camshaft cover Lower clean air inlet duct Upper clean air inlet duct Camshaft cover vent hose Air cleaner housing Engine Emission Control - Overview OVER

 Wheel Knuckle

Special Tool(s) 205-754A Splitter, Ball Joints 205-857 Remover, Halfshaft JLR-204-804 Lever, Wheel Knuckle Removal CAUTIONS: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Do not allow halfshafts to hang unsupported at one end or joint damage will occur. Make

© 2011-2026 Copyright www.rrevoque.org