Range Rover Evoque: Cleaning the sensors
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Parking aids / Cleaning the sensors
When washing the vehicle do
not aim
high pressure water jets directly at the
sensors. Do not use abrasive materials
or hard/sharp objects to clean the
sensors. Only use approved vehicle
shampoo.
The sensors should be kept clean to maintain accuracy and performance.
READ NEXT:
System fault
If a system fault is detected, a long
high-pitched tone will sound and the switch
indicator will flash. A message will be displayed
in the message centre. Contact your Dealer/
Authorised Repairer
Rear view camera
It remains the driver's
responsibility
to detect obstacles and estimate the
vehicle's distance from them when
reversing.
When Reverse (R) is selected the camera
provides a wide-angle rear view
SEE MORE:
Condenser GTDi 2.0L Petrol
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTES:
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer t
Foot brakes
Do not rest your foot on the
brake
pedal while the vehicle is in motion.
Never allow the vehicle to coast
(freewheel) with the engine turned off.
The engine must be running to provide
full braking assistance. The brakes
will still function with the engine off,
but far more pressure will be
© 2011-2025 Copyright www.rrevoque.org
