Range Rover Evoque manuals

Range Rover Evoque: Evaporator Temperature Sensor

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Climate Control System / Climate Control / Evaporator Temperature Sensor

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).

3.

Range Rover Evoque. Climate Control

4.

Range Rover Evoque. Climate Control

5.

Range Rover Evoque. Climate Control

6.

Range Rover Evoque. Climate Control

Installation

1. To install, reverse the removal procedure.

Heater Core TD4 2.2L Diesel

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03A Engine Cooling - TD4 2.2L Diesel, General Procedures).

3. Refer to: Electric Booster Heater (412-02 Auxiliary Climate Control, Removal and Installation).

4. CAUTION: Be prepared to collect escaping coolant.

Range Rover Evoque. Climate Control

5.

Range Rover Evoque. Climate Control

6. CAUTION: Be prepared to collect escaping coolant.

Range Rover Evoque. Climate Control

Installation

1. To install, reverse the removal procedure.

READ NEXT:

 Condenser TD4 2.2L Diesel

Removal CAUTION: Make sure that all openings are sealed. Use new blanking caps. NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur

 Heater Core and Evaporator Core Housing

Removal NOTE: Removal steps in this procedure may contain installation details. 1. Make the SRS system safe. Refer to: Standard Workshop Practices (100-00 General Information, Description and Operati

 Defrost Vent/Register Blend Door Actuator LHD AWD/LHD FWD

Removal NOTE: Removal steps in this procedure may contain installation details. 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

SEE MORE:

 Transmission Vehicles With: M66 6-Speed Manual Transmission FWD - Installation

Installation Special Tool(s) 303-021 Engine support bracket 303-662 Support Beam Arm and Hook Assembly, Engine NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. NOTE: This step is only required if previously removed. 2. NOTE: This step is only

 Cooling System Draining, Filling and Bleeding

Draining CAUTIONS: The engine cooling system must be maintained with the correct concentration and type of anti-freeze solution to prevent corrosion and frost damage. Failure to follow this instruction may result in damage to the engine. Engine coolant will damage the paint finished surfaces. If

© 2011-2025 Copyright www.rrevoque.org