Range Rover Evoque manuals

Range Rover Evoque: If the engine fails to start

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / If the engine fails to start

Note: If the engine fails to crank when the START/STOP button is pressed and there has been a recent collision, seek qualified assistance.

If the engine fails to crank, or fails to start, consult your Dealer/Authorised Repairer.

Diesel engines:

If the engine persistently fails to start, make sure the transmission is in P or N (neutral for manual transmission vehicles) then press the START/STOP button (with the brake pedal applied). Keep the START/STOP button and the brake pedal pressed until the engine starts, then release.

If the engine still fails to crank, or fails to start consult your Dealer/Authorised Repairer.

READ NEXT:

 Switching off the engine

Before switching off the engine, ensure that the vehicle is parked safely with the park brake applied. 1. Select P for automatic transmission, or neutral for manual transmissions. Note: If any ot

 Switching off the engine with the vehicle moving

It is not advisable to switch off the engine while the vehicle is moving. However, should such a situation arise, then the following procedure applies. - Press and hold the engine START/STOP

 Rolling re-start

If the engine is switched off while the vehicle is moving, a rolling re-start can be initiated. Automatic transmission - select neutral (N) and then press the engine START/STOP button. When the en

SEE MORE:

 Side Air Curtain Module

Removal CAUTION: Do not allow the side air curtain module to twist. Failure to follow this instruction may result in damage to the component. NOTES: Removal steps in this procedure may contain installation details. RH illustration shown, LH is similar. 1. Disconnect the battery ground cable. Refe

 Rear Bumper Mounting

Removal NOTE: The rear bumper mounting is manufactured from mild steel. 1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig. 2. The rear bumper mounting is replaced in conjunction with: Rear bumper cover Rear bumper Back panel 3.

© 2011-2025 Copyright www.rrevoque.org