Range Rover Evoque: Power Liftgate Switch, Liftgate
Power Liftgate Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. Torque: 4 Nm
3. Torque: 4 Nm
4.
Installation
1. To install, reverse the removal procedure.
Liftgate
Removal
CAUTION: The headliner must be lowered as a complete unit to gain access to the electrical connections. Partial lowering of the headliner may cause damage.
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Rear Spoiler (501-08 Exterior Trim and Ornamentation, Removal and Installation).
2.
3.
4.
5. Support the liftgate in the open position.
6. CAUTIONS:
Use a suitable sharp pointed hook, release the retaining clip (do not fully remove the clip).
Protect the surrounding paintwork to avoid damage.
Protect the surrounding components.
NOTES:
The step must be carried out on both sides.
Note the orientation of the clip.
7. CAUTIONS:
Take extra care not to damage the wiring harnesses.
Make sure the tailgate harnesses are withdrawn through the body harness apertures when removing the tailgate.
NOTES:
This step requires the aid of another technician.
Note the position of the wiring harnesses to aid installation.
8. NOTE: Do not disassemble further if the component is removed for access only.
Refer to: Liftgate Window Glass (501-11 Glass, Frames and Mechanisms, Removal and Installation).
9. NOTE: The step must be carried out on both sides.
10. CAUTIONS:
Use a suitable sharp pointed hook, release the retaining clip (do not fully remove the clip).
Protect the surrounding paintwork to avoid damage.
Protect the surrounding components.
NOTES:
The step must be carried out on both sides.
Note the orientation of the clip.
11. Refer to: Liftgate Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
12. Torque: 5 Nm
13.
14.
15.
16. Refer to: Rear Window Wiper Motor (501-16 Wipers and Washers, Removal and Installation).
Installation
1. NOTE: Make sure that the clips are installed in the correct orientation.
To install, reverse the removal procedure.
2. Check the liftgate alignment.
Refer to: Liftgate Alignment (501-03 Body Closures, General Procedures).
READ NEXT:
Rear Door
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Disconnect the bat
Fuel Filler Door
Removal
CAUTION: Make sure to protect the paintwork.
1.
Installation
1.
Fuel Filler Door Assembly
Removal
WARNING: Avoid flames, sparks or lighted substances.
CAUTION: Extreme cleanliness must be ex
Body Closures - Component Location, System Operation and Component
Description
Component Location
Powered Tailgate - Component Location
Tailgate module
Powered strut
Tailgate open button
Tailgate close button
Latch assembly
Powered cinch motor
Powered strut
OVERVIEW
Ta
SEE MORE:
Dual view control menu
Dual view control menu
1. Select to cancel dual view and revert to the
menu for the current video source (TV,
DVD).
Note: The preview screen will be
deactivated if the vehicle is moving.
2. Select to view a list of all available video
sources. Touch the relevant soft key to
select an alter
Checking the tyre pressure after a repair
When driving the vehicle, if
you
experience vibrations, abnormal
steering, or noises, reduce speed
immediately. Drive with extreme
caution and reduced speed to the first
safe place to stop the vehicle. Visually
examine the tyre, and check its
pressure. If there are any signs of
damage or
