Range Rover Evoque: Pairing and connecting from the touch screen

Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Telephone / Pairing and connecting from the touch screen

1. Switch on your mobile phone’s Bluetooth® connection. Make sure that your mobile phone is in Bluetooth® discoverable mode, sometimes referred to as find me mode (see your phone’s operating instructions for more information).

2. Switch the ignition on and ensure that the touch screen is active.

3. From the home menu select Phone.

4. A menu will appear. Select Search new.

5. Select Vehicle to device option.

6. Identify your phone from the displayed list and select the corresponding Pair and connect option.

Note: If more than 5 devices are detected, it may be necessary to use the scroll bar to see the entire list.

7. When prompted, enter the PIN code into your phone. See your phone’s operating instructions for further information.

8. Once your phone is paired and connected to the system, a confirmation message will be displayed before switching to the Digit Dial screen.

Note: Due to the duration of a Bluetooth® search, it is advised that the timeout to home screen feature is switched off before attempting to search for Bluetooth® devices.
This setting can be changed within Vehicle, Syst settings, Display set, Timeout to home screen.

READ NEXT:

 Changing the connected phone

Up to 10 mobile phones can be paired with the vehicle in the same way. However, only one can be connected and ready for use as a phone at any one time. To connect a different paired phone, follow

 Touch screen icons

Connect. Use to send or accept a call and access last 10 dialled numbers. Disconnect. Use to end or reject a call. No phone connected. Phone signal strength indicator. Phone battery l

 Steering wheel icons

Connect. Press and release to send or accept a call or to access the last 10 dialled list. Press and hold to access the phonebook. Disconnect. Use to end or reject a call. Voice control t

SEE MORE:

 Changing the smart key batttery

When the battery needs renewing, there will be a significant decrease in the effective range and the message SMART KEY BATTERY LOW will be displayed in the message centre. To renew the battery: 1. Slide open the side cover. 2. Remove the emergency key and fit into the receiver. 3. With the

 Sand

This program should be used for terrain which is predominantly soft dry sand or deep gravel. Note: If the vehicle is unable to gain traction in extremely soft, dry sand, switching DSC off may help. DSC should be switched on again as soon as the difficulty is overcome. If the sand to be cros

© 2011-2025 Copyright www.rrevoque.org