Control Diagram
NOTE: A = Hardwired; D = High Speed CAN (controller area network) bus; N =
Medium Speed CAN bus; O = LIN
(local interconnect network) bus
DW12C is shown, GTDi is similar
Battery
B
ATC MODULE
NOTE: The 'ECON' button has been renamed 'A/C' to prevent confusion with
the Stop/Start system 'Eco' switch.
The ATC module is mounted in the center console and is integral with the
cont
Removal
CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTES:
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps
Removal
NOTE: If a new Active on-demand coupling module is installed, the throttle
valve must also be installed.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2.
3. CAUTIONS:
Make sure that the area around the component is
clean and free of foreign m
Component Location
RH (right-hand) spring and damper assembly
Stabilizer link
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Hub
Longitudinal link
Rear transverse link
Front transverse link
Subframe
Overview
The rear suspension features long travel McPherson stru