Range Rover Evoque: Rear Lower Arm FWD
Removal
NOTES:
LH illustration shown, RH is similar.
Some variation in the illustrations may occur, but the essential information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3. NOTE: All wheel drive transmission illustrations shown, front wheel drive transmission is similar.
4. CAUTION: Note the fitted position of the special washer.
5.
6.
7. NOTE: Do not disassemble further if the component is removed for access only.
Installation
1. NOTE: This step is only required if previously removed.
2. CAUTION: Only tighten the nut and bolt finger-tight at this stage.
3. CAUTION: Only tighten the nut and bolt finger-tight at this stage.
4. CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension. Support weight of vehicle on a jack at the rear hub.
5.
6. Torque: 175 Nm
7. CAUTION: Note the fitted position of the special washer.
8. Torque: 175 Nm
9. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
10. Check and if necessary, adjust the rear wheel alignment
READ NEXT:
Rear Suspension FWD
Component Location
Stabilizer link
RH (right-hand) spring and damper assembly
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Stub axle and locknut
Hub
Longitudinal li
Wheels and Tires
Wheel and Tire
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. NOTE: Ma
Vehicle Dynamic Suspension
Vehicle Dynamic Suspension - Component
Location
COMPONENT LOCATION
RH (right-hand) rear spring and damper assembly
RH rear height sensor
LH (left-hand) rear spring and damper assembly
LH rear he
SEE MORE:
Engine compartment overview
Engine compartment overview
2.0L petrol engine
1. Brake/clutch fluid reservoir caps (beneath
covers):
A. Left-hand drive vehicles.
B. Right-hand drive vehicles.
2. Engine oil filler cap.
5. Oil level dipstick.
6. Washer fluid filler cap.
7. Engine coolant filler cap.
Do not drive if the
B-Pillar Lower Trim Panel, D-Pillar Trim Panel
B-Pillar Lower Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3.
4. CAUTION: Discard the bolt.
Torque: 45 Nm
5.
6.
Installation
1. WARNING: Make sure that a new bolt is installed.
CAUTION: Make sure the safety belt is secure and correctly
inst
