Range Rover Evoque: Rear Suspension
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Suspension / Rear Suspension
- Rear Suspension AWD
- Rear Wheel Bearing
- Front Lower Arm
- Rear Lower Arm AWD
- Rear Stabilizer Bar
- Wheel Knuckle
- Rear Shock Absorber Vehicles Without: Dynamic Suspension
- Shock Absorber and Spring Assembly Vehicles Without: Dynamic Suspension
- Wheel Knuckle Rear Bushing
- Rear Shock Absorber Vehicles With: Dynamic Suspension
- Shock Absorber and Spring Assembly Vehicles With: Dynamic Suspension
- Spring Vehicles Without: Dynamic Suspension
- Rear Lower Arm FWD
- Rear Suspension FWD
READ NEXT:
Rear Suspension AWD
Component Location
RH (right-hand) spring and damper assembly
Stabilizer link
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Hub
Longitudinal link
Rear transverse lin
Rear Wheel Bearing
Special Tool(s)
204-250
Wheel bearing install and removal tool
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-809
Installer, Re
Front Lower Arm
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Front wheel drive transmission illustrations shown, all wheel wheel drive
transmission
SEE MORE:
Front Seat Track Motor
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
1. Raise the front seat to the highest position.
2. Disconnect the battery ground cable.
Refer to: Specifications (414-0
Power Brake Actuation
Brake Booster - Component Location
COMPONENT LOCATION - 2.2L Td4
NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive)
installation similar
Brake booster
Vacuum pipe (vehicles with stop/start system)
Vacuum pump
Vacuum pipe (vehicles without stop/start system)
Non return val
© 2011-2025 Copyright www.rrevoque.org
