Range Rover Evoque: Wheel Knuckle Rear Bushing
Special Tool(s)
204-620-01
Installer, Wheel Knuckle Bushing
204-620-02
Remover/Installer, Wheel Knuckle Bushing
204-620-03
Remover, Wheel Knuckle Bushing
LR-121
Hydraulic Cylinder 10t
Removal
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Remove the wheel and tire.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
3.
4.
5. CAUTION: Note the position of the component and mark the surrounding area to aid installation.
6. Remove the bushing.
Special Tool(s): LR-121, 204-620-02, 204-620-03
Installation
1. CAUTION: Make sure that the component is installed to the position noted on removal.
2. CAUTION: Make sure the correct special tool is used to install the bushings to the correct depth.
Install the bushing.
Special Tool(s): LR-121, 204-620-01, 204-620-02
3. Torque: 270 Nm
4. Torque: 110 Nm
5. Install the wheel and tire.
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).
READ NEXT:
Rear Shock Absorber Vehicles With: Dynamic
Suspension
General Equipment
Suspension Spring Compressor
Vise
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds
the spring rating quoted in the
Specifcations sectio
Shock Absorber and Spring Assembly Vehicles With:
Dynamic Suspension
Special Tool(s)
JLR-204-804
Lever, Wheel Knuckle
General Equipment
Transmission jack
Wooden Block
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspensi
Spring Vehicles Without: Dynamic Suspension
Removal
WARNINGS:
Make sure the spring compressor Safe Working Load (SWL) meets or exceeds
the spring rating quoted in the
Specifcations section.
Always follow the spring compressor manufacturer's i
SEE MORE:
Mislock
When locking the vehicle with the Smart Key, if
one or more of the doors, the bonnet or the
tailgate is not fully closed, or the ignition is ON,
the vehicle will NOT lock and there will be an
audible mislock error warning. The hazard
warning lamps will NOT flash and the door
mirrors (if enable
Winter tyres
In many countries legislation exists that
requires the use of winter tyres during
specified periods of the year.
M+S tyres have a recognised level of winter
performance and need not be replaced.
When changing to winter tyres, they must be
fitted to all four wheels.
If the vehicle has TPMS but
