Range Rover Evoque manuals

Range Rover Evoque: Intake Manifold

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Engine - GTDi 2.0L Petrol / Intake Manifold

Removal

NOTES:

Removal steps in this procedure may contain installation details.

Some illustrations may show the engine removed for clarity.

1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

2. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

3. Refer to: Engine Cover - GTDi 2.0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).

4.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

5.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

6.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

7.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

8.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

9.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

10.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

11. NOTE: Do not disassemble further if the component is removed for access only. Torque: 8 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

12.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

13. Torque: 5 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

Installation

1. To install, reverse the removal procedure.

2. CAUTIONS:

Tighten the bolts in the sequence shown.

Make sure that the mating faces are clean and free of foreign material.

Torque: 20 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

READ NEXT:

 Oil Cooler

Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Disconnect the battery

 Oil Pan

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

 Oil Pump

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

SEE MORE:

 Battery and Charging System - General Information

Battery Care Requirements 1. INTRODUCTION This document sets out the requirements for care and maintenance of batteries and thereby the standard of battery care at dealers and retailers for new vehicles This applies to all types of 12 Volt Lead Acid Batteries used in Jaguar and Land Rover vehicles

 Transfer Case Seal RH TD4 2.2L Diesel

Special Tool(s) 100-012 Slide Hammer 205-872 Installer, Transfer Case Seal 308-615 Remover, Seals 308-617 Depth Drill, Seal Remover Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is alway

© 2011-2025 Copyright www.rrevoque.org