Range Rover Evoque: Engine
- Engine System - General Information
- Engine - GTDi 2.0L Petrol
- Engine - Component Location, System Operation and Component Description
- Engine Oil Draining and Filling, Camshafts
- Cylinder Head
- Engine Mount LH/RH
- Intake Manifold
- Oil Cooler
- Oil Pan
- Oil Pump
- Timing Chain
- Timing Cover
- Valve Cover
- Engine - Removal and Installation
- Engine Upper/Lower Support Insulator
- Oil Filter Housing
- Balance Shaft Assembly
- Engine - Diagnosis and Testing
- Engine Timing
- Engine Cooling - GTDi 2.0L Petrol
- Engine Cooling - Component Location, System Operation and Component Description
- Cooling System Draining, Filling and Bleeding
- Radiator
- Cooling Fan
- Cooling System Partial Draining, Filling and Bleeding
- Engine Cooling - Diagnosis and Testing
- Block Heater
- Fuel Charging and Controls - GTDi 2.0L Petrol
- Fuel Charging and Controls - Component Location, System Operation and Component Description
- Throttle Body
- Fuel Rail
- Fuel Pump
- Fuel Charging and Controls - Turbocharger - GTDi 2.0L Petrol
- Accessory Drive - GTDi 2.0L Petrol
- Starting System - GTDi 2.0L Petrol
- Engine Ignition - GTDi 2.0L Petrol
- Engine Emission Control - GTDi 2.0L Petrol
- Intake Air Distribution and Filtering - GTDi 2.0L Petrol
- Evaporative Emissions - GTDi 2.0L Petrol
- Electronic Engine Controls - GTDi 2.0L Petrol
READ NEXT:
Engine System - General Information
Cylinder Head Gasket Selection TD4
2.2L Diesel
Special Tool(s)
303-979
Measuring Bridge, Piston Protusion
1. CAUTION: Make sure that the surface is clean and
free of foreign material.
Zero the gauge o
Engine - Component Location, System Operation and Component
Description
Component Location
EXTERNAL VIEW
Overview
OVERVIEW
The 2.0L Gasoline Turbocharged Direct Injection (GTDi) engine is an in-line,
double overhead camshaft, 4 cylinder engine,
which is transverse mount
SEE MORE:
Floor Console
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and
Console, Removal and Installation).
2. NOTES:
The step must be carried out on both sides.
LH illustration shown, RH is similar.
3. NOTES:
The step m
Transmission Fluid Level Check
Check
WARNING: Observe due care when draining, as the fluid can be very hot.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. Make sure that the automatic transmission is in the PARK position
and the handbrake is fully applied.
2. WARNING: Ma
© 2011-2025 Copyright www.rrevoque.org
