Range Rover Evoque: Floor Console Upper Section
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. CAUTION: The procedure must be carried out on both sides.
NOTE: LH illustration shown, RH is similar.
Torque: 1.9 Nm
Vehicles with manual transmission
2. Refer to: Gearshift Lever Knob (308-06 Manual Transmission/Transaxle External Controls, Removal and Installation).
3. CAUTION: Carefully release the retaining clips.
4.
5. CAUTION: Carefully release the retaining clips.
Vehicles with automatic transmission
6. CAUTION: Carefully release the retaining clips.
7.
All vehicles
8. NOTE: Do not disassemble further if the component is removed for access only.
Torque:
M5 bolt 1.5 Nm
Screw 1.1 Nm
9. Torque: 1.1 Nm
10. Torque: 1.1 Nm
11. Torque: 1.1 Nm
12. Torque: 1.1 Nm
Installation
1. To install, reverse the removal procedure.
2. Connect Land Rover approved diagnostic equipment to vehicle. Read and clear the stored DTCs.
Torque Specifications
READ NEXT:
Locks, Latches and Entry Systems
Principle of Operation
For a detailed description of the locks, latches and entry systems and
operation, refer to the relevant Description and
Operation section of the workshop manual REFER to: Handl
SEE MORE:
Removing the temporary spare wheel
Remove the spare wheel prior
to
jacking the vehicle, to avoid
destabilising the vehicle when raised.
Do not use power tools to
loosen the
spare wheel. Doing so may damage the
mechanism.
1. To access the temporary spare wheel, fold
forward the rear edge of the cover then
remove it.
2.
Fuel Tank
Special Tool(s)
310-123
Locking Ring, Fuel Tank
Removal
WARNINGS:
Fuel may still be present in the fuel tank after draining.
Avoid flames, sparks or lighted substances.
CAUTIONS:
Extreme cleanliness must be exercised when handling these components.
Make sure that all openings are sealed. Use new
