Range Rover Evoque: Instrument Panel Upper Section
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
3. NOTE: The procedure must be carried out on both sides. Refer to: A-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
4. Refer to: Steering Column (211-04 Steering Column, Removal and Installation).
5. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).
6. Refer to: Glove Compartment (501-12 Instrument Panel and Console, Removal and Installation).
7. NOTES:
The step must be carried out on both sides.
LH illustration shown, RH is similar.
Torque:
Screw 17mm 1.9 Nm
Screw 13mm 1.1 Nm
8.
9. Torque: 1 Nm
10.
11. Torque: 1.5 Nm
12. CAUTION: Take extra care not to damage the instrument cluster face.
13.
14. Torque: 6 Nm
15.
16. CAUTION: Care must be taken to avoid damage to the internal components of the center registers.
Torque: 1.5 Nm
17. Torque: 1.5 Nm
18.
19.
20. Torque: 6 Nm
21. CAUTION: Protect the surrounding trim to avoid damage.
NOTE: With assistance remove the component.
Torque: 6 Nm
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Floor Console
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and
Console, Removal and Installation).
2. NOTES:
The
Overhead Console
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. CAUTION: Take extra care not to damage the
edges of the component.
2.
3. NOTE: Do not disassemble further if the
co
Floor Console Upper Section
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. CAUTION: The procedure must be carried out on
both sides.
NOTE: LH illustration shown, RH is similar.
T
SEE MORE:
If the engine fails to start
Note: If the engine fails to crank when the
START/STOP button is pressed and there has
been a recent collision, seek qualified
assistance.
If the engine fails to crank, or fails to start,
consult your Dealer/Authorised Repairer.
Diesel engines:
If the engine persistently fails to start, make
Airbag service information
Do not attempt to service,
repair,
replace, modify, or tamper with, any
part of the SRS. This includes wiring
or components in the vicinity of SRS
components. Doing so may cause the
system to trigger, or render the
system inoperative.
Do not use any electrical test
equipment or devices in
