Range Rover Evoque: Navigation System

Navigation System

Principles of Operation

NOTE: This navigation system is installed in selected Asia market vehicles only.

For a detailed description of the navigation system, refer to the relevant Description and Operation section of the workshop manual. REFER to: (415-01 Information and Entertainment System)

Inspection and Verification

CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle.

NOTE: Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests.

1. Verify the customer concern

2. Visually inspect for obvious signs of damage, water ingress and system integrity

Visual Inspection

Range Rover Evoque. Navigation System

3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step

4. If the cause is not visually evident, verify the symptom and refer to the Symptom Chart

Symptom Chart

Range Rover Evoque. Navigation System

Range Rover Evoque. Navigation System

Pinpoint Tests

NOTE: If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval Program is in operation, prior to the installation of a new module/component.

Range Rover Evoque. Navigation System

Navigation Control Module Locations

Range Rover Evoque. Navigation System

Range Rover Evoque. Navigation System

DTC Index

For a list of diagnostic trouble codes that could be logged on this vehicle, please refer to Section 100-00.

REFER to: Diagnostic Trouble Code (DTC) Index - DTC: Navigation Control Module (NCM) (100-00, Description and Operation) / Diagnostic Trouble Code (DTC) Index - DTC: Touch Screen (TS) (100-00 General Information, Description and Operation).

READ NEXT:

 Multifunction Electronic Modules

Torque Specifications Front Door Module (FDM) Removal NOTE: Removal steps in this procedure may contain installation details. 1. Disconnect the battery ground cable. Refer to: Specifications (414-01

SEE MORE:

 Rear Side Member Upper Side Extension

Removal NOTES: The rear side member upper side extension is manufactured from mild steel. If a new Rear side member upper side extension is being replaced in combination with a rear side member closing panel some MIG plug welds can be substituted for spot welds on installation within this procedu

 Voice tutorial

To listen to a tutorial detailing the operation of the Voice system: - Briefly press the Voice button to start a voice session. - Wait for the tone to sound, then say Voice tutorial. Alternatively, the tutorial can be selected using the touch screen, as follows. - Select Setup from the touch

© 2011-2025 Copyright www.rrevoque.org