Range Rover Evoque: Seat belt pre-tensioners

The seat belt pre-tensioners activate in conjunction with the SRS to provide additional protection in the event of a severe frontal impact. They automatically reduce any slack in a seat belt to reduce forward movement of a front seat occupant.

will The seat belt pre-tensioners will activate only once and then must be replaced. Failure to replace them will reduce the effectiveness of the SRS in reducing the risk of serious injury or death in the event of an accident.

After any impact, have the seat belts and pre-tensioners checked and, if necessary, replaced by a Land Rover Dealer/Authorised Repairer.

READ NEXT:

 Seat belt safety

Care should be taken to avoid contamination of the webbing with polishes, oils and chemicals, and particularly battery acid. Cleaning may safely be carried out using mild soap and water. The be

 Seat belt checks

Note: If the vehicle is parked on an incline, the seat belt mechanism may lock. This is not a fault and the belt should be gently eased out from the upper anchorage. The seat belts should be inspe

 Seat belt reminder

Seat belt reminder If a front seat belt is not fastened when the vehicle is in motion, a chime will be heard and the seat belt warning lamp will illuminate. Note: Objects on the front passenger

SEE MORE:

 B-Pillar Reinforcement

Removal NOTES: The B-Pillar reinforcement is manufactured from boron steel. The B-Pillar reinforcement is unpicked from the side panel reinforcement, 'ring-frame', it is not serviced separately. There are 2 NVH components serviced on the new B-Pillar reinforcement. 1. The B-Pillar reinforcement i

 Front Side Member

Removal NOTES: The front side member is manufactured from RP260 and DP600. The front side member long section is cut from the front side member and is manufactured from RP260. The service panel is serviced not fully spot welded. 1. In this procedure, to make sure the vehicle is correctly aligned,

© 2011-2024 Copyright www.rrevoque.org