Range Rover Evoque: Occupant safety
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Occupant safety
- Occupant safety using seat belts
- Seat belt pre-tensioners
- Seat belt safety
- Seat belt checks
- Seat belt reminder
- Beltminder
- Child seats
- Child seat positioning
- Recommended child seats
- Child restraint check list
- Isofix anchor points (not Australia)
- Isofix child seat positions
- Booster cushions
- Installing an isofix child seat
- Tether anchorage points (Australia only)
- Attaching tether straps
- Airbag supplementary restraint system (SRS)
- Airbag operation
- Disabling the passenger airbag (not Australia)
- Front airbags
- Side airbags
- Curtain airbags
- Airbag deployment effects
- Airbag warning lamp
- Airbag service information
- Disability modifications
READ NEXT:
Occupant safety using seat belts
Occupant safety using seat belts
1. Putting on a seat belt:
Draw the belt out smoothly, ensure that the
belt height, the seat and your position on
the seat, are correct.
WARNING:
Seatbelts a
Seat belt pre-tensioners
The seat belt pre-tensioners activate in
conjunction with the SRS to provide additional
protection in the event of a severe frontal
impact. They automatically reduce any slack in
a seat belt to re
Seat belt safety
Care should be taken to avoid
contamination of the webbing with
polishes, oils and chemicals, and
particularly battery acid. Cleaning
may safely be carried out using mild
soap and water.
The be
SEE MORE:
Restraints Control Module (RCM)
Removal
NOTES:
The RCM must be replaced after every time any SRS component has been
deployed.
Removal steps in this procedure may contain installation details.
1. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information,
Description and Operation).
2. Disconnect
Drive Pinion Front Bearing
Special Tool(s)
100-012
Slide Hammer
205-067
Preload Gauge
308-615
Remover, Seals
JLR-205-972
Mounting Bracket, Rear Axle
JLR-205-984
Remover/Installer, Drive Pinion Nut
JLR-205-985
Remover, Drive Pinion Bearing
JLR-205-986
Installer, Drive Pinion Bearing
Removal
1. Raise and support the vehicle.
2.
© 2011-2024 Copyright www.rrevoque.org
