Range Rover Evoque: Child restraint check list

Every time a child travels in the vehicle observe the following:
- Use appropriate child restraints.

- Carefully follow the restraint system manufacturers instructions.

- Adjust the harnesses for every child on every trip.

- Ensure that all slack is removed from the adult seat belt.

- Always attach the top tether when installing an ISOFIX seat.

- Always check the security of the child restraint.

- Do not dress a child in bulky clothing, or place any objects/padding between the child and the restraint.

- Regularly check the fit and condition of child restraints. If the fit is poor, or wear/damage is visible replace the restraint immediately.

- Set a good example - always wear your seat belt.

anchorages WARNING: Child restraint anchorages are designed to withstand only those loads imposed by correctly fitted child restraints. Under no circumstances are they to be used for adult seat belts, harnesses or for attaching other items or equipment to the vehicle.

READ NEXT:

 Isofix anchor points (not Australia)

Do not attempt to fit ISOFIX restraints to the centre rear seating position. The anchor bars are not designed to hold an ISOFIX restraint in this position. If the restraint is not correctly a

 Isofix child seat positions

Isofix child seat positions - IUF = Suitable for ISOFIX forward child restraint systems of universal category approved for use in the mass group. - IL = These ISOFIX child restraint systems are

 Booster cushions

In a situation where a child is too large to fit into a child safety seat but is still too small to safely use just the three point belt, a booster seat is recommended for maximum safety. Follow t

SEE MORE:

 Voicetags

Voicetags enable the user to personalise the Voice system so that a single name can be used to call-up a navigation destination, telephone number or radio channel. To add a Voicetag: 1. Briefly press the Voice button to start a Voice session. 2. Wait for the tone to sound then say Phone, Nav

 Front Side Member Closing Panel

Removal NOTES: The front side member closing panel is manufactured from RP260. The front side member closing panel is serviced as part of the front side member and suspension top mount assembly. This method describes the LH front side member closing panel, the RH side is similar. The panel is s

© 2011-2023 Copyright www.rrevoque.org