Range Rover Evoque: Selecting valet mode

Valet mode allows the vehicle to be driven, e.g., by a parking attendant, but leaves the tailgate locked and restricts use of the touch screen.

This prevents access to telephone numbers, navigation addresses and audio system settings.

From the Home menu, select Valet: Enter a four digit Personal identification Number (PIN) (personally chosen). On completion, touch the OK soft key.

If you wish to cancel the PIN, select Delete.

After entering the PIN, you will be prompted to enter the PIN again. Enter the same PIN and touch OK to confirm.

A pop-up screen is displayed, confirming your vehicle is now in Valet mode.

READ NEXT:

 Interior protection

The interior protection feature of the full alarm system may be temporarily disabled via Alarm sensors in the Vehicle Settings menu. See 56, VEHICLE INFORMATION AND SETTINGS MENU. Note: If the in

 Battery-backed sounder

In certain markets, a battery backed sounder is fitted. This device will sound if it or the vehicle battery is disconnected while the security system is armed.

 Tilt sensor

The tilt sensor detects any change to the vehicle’s angle to the ground. When the alarm is armed and the vehicle is double locked, any change in the vehicle’s angle will activate the tilt alar

SEE MORE:

 Before driving off-road

Before venturing off-road, it is absolutely essential that inexperienced drivers become fully familiar with the vehicle's controls. In particular Hill Descent Control (HDC) and the Terrain Response system. Basic guidance for Off-Road driving can be found in the Land Rover Off-Road Driving han

 Inner Back Panel Assembly

Removal NOTES: The inner back panel assembly is manufactured from mild steel. The panel is serviced less its weld studs. The new service panel is not fully spot welded when supplied. It is necessary to remove a section of one rear lamp mounting panel to enable removal and installation of the inn

© 2011-2025 Copyright www.rrevoque.org