Range Rover Evoque: Bulb check
A warning lamp bulb check is initiated when the ignition system is switched on and lasts for 3 seconds (except for the airbag warning lamp which will remain on for 6 seconds). If any warning lamp remains on after this period, investigate the cause before driving.
Some warning lamps have associated messages displayed on the message centre.
Note: Not all warning lamps are included in the check (e.g. high beam headlamps and direction indicators).
READ NEXT:
Critical warning message (red)
Critical warning message (red)
Illuminates when a critical warning
message is available in the
message centre.
Low oil pressure (red)
Low oil pressure (red)
Illuminates briefly when the
ignition is switched on and
extinguishes when the engine is
started. If the lamp remains on, flashes or
illuminates while driving, stop the v
Brake systems (red)
Brake systems (red)
Illuminates briefly when the
ignition is switched on. If the lamp
illuminates while driving, suspect
low brake fluid level or a fault with the
Electronic Brake Distribution
SEE MORE:
Multifunction Electronic Modules
Torque Specifications
Front Door Module (FDM)
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Refer to: Front Door Trim Panel (501-05 Interior
Touch screen care
Do not use abrasive cleaners
on the
touch screen. For approved cleaning
products, contact your Dealer/
Authorised Repairer.
The touch screen and inner bezel must be kept
clean to maintain optimum performance. Clean
finger marks with a soft cloth and Land Rover
approved cleaning agent. Cont
© 2011-2025 Copyright www.rrevoque.org
