Range Rover Evoque: Warning lamps
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Warning lamps
- Warning lamps
- Bulb check
- Critical warning message (red)
- Low oil pressure (red)
- Brake systems (red)
- Parking brake (red)
- Battery charge (red)
- Seat belt (red)
- Engine malfunction (amber)
- General warning/information message (amber)
- Brake systems (amber)
- Dynamic stability control (amber)
- Dynamic stability control off (amber)
- Anti-lock braking system (amber)
- Airbag srs (amber)
- Adaptive front lighting (amber)
- Rear fog lamps (amber)
- Diesel glow plug (amber)
- External temperature (amber)
- Tyre pressure monitoring (yellow)
- Hill descent control (green)
- Cruise control active (green)
- Side lamps (green)
- Front fog lamps (green)
- Direction indicators (green)
- Trailer direction indicators (green)
- Auto high beam (green)
- High beam (blue)
- Eco active (green)
READ NEXT:
Warning lamps
RED warning lamps are for primary warnings.
A primary warning must be investigated
immediately.
Seek qualified assistance before continuing.
AMBER and YELLOW warning lamps are for
secondary warni
Bulb check
A warning lamp bulb check is initiated when the
ignition system is switched on and lasts for 3
seconds (except for the airbag warning lamp
which will remain on for 6 seconds). If any
warning lamp
Critical warning message (red)
Critical warning message (red)
Illuminates when a critical warning
message is available in the
message centre.
SEE MORE:
Front/Rear Door Window Glass
Front Door Window Glass
Special Tool(s)
501-114
Release Lever, Door Glass
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 1 Nm
2. Special Tool(s): 501-114
3.
Installation
1. NOTE: An audible click is heard when the clips are fully
latched.
To install, re
Engine System - General Information
Cylinder Head Gasket Selection TD4
2.2L Diesel
Special Tool(s)
303-979
Measuring Bridge, Piston Protusion
1. CAUTION: Make sure that the surface is clean and
free of foreign material.
Zero the gauge on the cylinder block machined face.
Special Tool(s): 303-979
2. CAUTION: Make sure that the surfac
© 2011-2025 Copyright www.rrevoque.org
