Range Rover Evoque: Suspending and resuming cruise control

Suspend cruise control with a single press of control (3).

To resume cruise control at the previous set speed, press control (2).

if the RES (2) should be used only if the driver is aware of the set speed and intends to return to it.
It is not recommended to resume set speed when a low gear is selected as excessive engine speeds will occur.

READ NEXT:

 Automatic switch off

Cruise control will switch off but the set speed will remain in the memory when: - The CAN button (3) is pressed. - The brake pedal is pressed. - Speed falls below 30km/h (18mph). - Neutral, Park

 Cruise eco data

Diesel only When enabled, a CO2 emission indicator is displayed in the message centre. The higher the numeric reading, the more CO2 is being emitted and the more fuel is being used. See 56, VEH

 Stability control

SEE MORE:

 Front Seat Recliner Motor

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications). 2. Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation). 3. Refer to: Front Seat Co

 Front Seat Track

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications). 2. WARNING: To avoid accidental deployment and possible personal injury, the backup po

© 2011-2025 Copyright www.rrevoque.org