Range Rover Evoque: Removing the temporary spare wheel

to Remove the spare wheel prior to jacking the vehicle, to avoid destabilising the vehicle when raised.

loosen the Do not use power tools to loosen the spare wheel. Doing so may damage the mechanism.

1. To access the temporary spare wheel, fold forward the rear edge of the cover then remove it.

2. Turn the temporary spare wheel locking ring counter clockwise to gain access to the retaining bolt.

3. Turn the retaining bolt counter clockwise until it comes free.

4. Remove the temporary spare wheel.

READ NEXT:

 Temporary spare wheel

Always adhere to the instructions given on the temporary use spare wheel warning label. Failure to comply can be dangerous. When a temporary use spare wheel is fitted, drive with caution and r

 Using wheel chocks

Note: Wheel chocks are not supplied as part of the tool kit. Wheel chocks are a useful addition to a vehicle tool kit. Note the following advice when using wheel chocks. Before raising the vehic

 Wheel changing safety

Before raising the vehicle or changing a wheel, ensure that you read and comply with the following warnings. Always find a safe place to stop, off the highway and away from traffic. Ensure tha

SEE MORE:

 Transmission Vehicles With: M66 6-Speed Manual Transmission FWD - Installation

Installation Special Tool(s) 303-021 Engine support bracket 303-662 Support Beam Arm and Hook Assembly, Engine NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. NOTE: This step is only required if previously removed. 2. NOTE: This step is only

 Using traction devices

Only use traction devices in heavy snow conditions, on hard road surfaces. Dynamic Stability Control (DSC) must be switched off when using traction devices. Never exceed 50 km/h (30 mph) when traction devices are fitted. Never fit traction devices to a temporary use spare wheel. Land Ro

© 2011-2025 Copyright www.rrevoque.org