Range Rover Evoque: Anti-Lock Control - Stability Assist

Accelerometer

Removal

NOTES:

Removal steps in this procedure may contain installation details.

LHD illustration shown, RHD is similar.

Vehicles with automatic transmission

1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and Console, Removal and Installation).

2. Torque: 9 Nm

Range Rover Evoque. Anti-Lock Control - Stability Assist

Vehicles with manual transmission

3. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation).

4.

Range Rover Evoque. Anti-Lock Control - Stability Assist

5.

Range Rover Evoque. Anti-Lock Control - Stability Assist

6. Torque: 9 Nm

Range Rover Evoque. Anti-Lock Control - Stability Assist

Installation

1. To install, reverse the removal procedure.

2. If a new component has been installed, configure using Land Rover approved diagnostic equipment.

READ NEXT:

 Steering System

 Power Steering

 Power Steering AWD

Component Location Steering gear Rubber seal assembly Heat shield Overview The vehicle is fitted with EPS (electric power steering), provided by a ZF Servolectric steering gear unit with variab

SEE MORE:

 Rear Seat Backrest Cover 5-Door

Removal NOTES: This procedure covers the removal and installation of both rear seat backrests and the LH rear seat backrest cover. The RH rear seat backrest cover is similar. All notes and cautions must be followed strictly to avoid any chance of NVH or failure of the rear seat backrests. Some v

 Using traction devices

Only use traction devices in heavy snow conditions, on hard road surfaces. Dynamic Stability Control (DSC) must be switched off when using traction devices. Never exceed 50 km/h (30 mph) when traction devices are fitted. Never fit traction devices to a temporary use spare wheel. Land Ro

© 2011-2025 Copyright www.rrevoque.org