Range Rover Evoque: Changing a bulb

been switched If the lighting has just been switched off, give the bulbs time to cool.
Handling them when hot may cause personal injury.

the correct Always replace bulbs with the correct type and specification. If you are in any doubt contact your Land Rover Dealer/Authorised Repairer for advice.
See 199, BULB SPECIFICATION CHART.
Before attempting a bulb change, ensure that the ignition and affected lamp are turned off. If the circuit remains live, a short circuit can occur which may damage the vehicle electrical system.

Not all bulbs are replaceable. The following bulbs can be replaced: - Headlamps.

- Direction indicators.

- Side lamps.

- Reversing lamp.

- Rear fog lamp.

- Some interior lamps.

All other exterior lamps and some interior lamps are LED (light emitting diode) lamps and can be replaced only by a Land Rover Dealer/Authorised Repairer.

All replacement procedures require the removal of components to gain access to the bulbs.

should be Moving a headlamp unit should be undertaken only by a qualified technician. If in doubt, consult your Land Rover Dealer.

Note: To change any bulb in a headlamp unit, a cross head screwdriver and a 10mm spanner is required.

READ NEXT:

 Xenon lamps

High voltage is required to ignite the gas and metal vapour which are used to power Xenon lamps. Contact with this voltage can cause serious injury. Replacement or maintenance of Xenon lamps s

 Headlamps

Moving the nearside headlamp unit to access bulbs; 1. Remove the two plastic fixings. 2. Pull the tube up to release from the air box. This will allow more room for manoeuvrability. 3. Remove

 Direction indicator and side lamp bulbs

Removing the nearside bulbs; To gain more room for accessibility, follow steps 1 and 2 for moving the nearside headlamp unit. 1. At the back of the headlamp unit, remove the indicator bulb hous

SEE MORE:

 Tyre pressure monitoring (TPM) system

The TPM system provides a low pressure warning and does not re-inflate your tyres. Tyre pressures should be checked regularly using an accurate pressure gauge when cold. The TPM system can NOT register damage to a tyre. Regularly check the condition of your tyres, especially if the vehicle

 Component Description

LEFT STEERING COLUMN MULTIFUNCTION SWITCH Off position Side lamps position Headlamps position AUTO - Automatic headlamps position (if fitted) Front fog lamps switch Rear fog lamps switch High beam Right turn signal indicator Left turn signal indicator High beam position High beam flash

© 2011-2025 Copyright www.rrevoque.org