Range Rover Evoque: Commandshift™

To return to Sport mode after CommandShift has been selected, move the selector back to D then back to Sport mode. Transmission Commandshift Selected will appear in the message centre when the transmission is in CommandShift mode.

Note: In order to protect the engine, the transmission will automatically change up to prevent over-revving, or down if the engine is labouring.

READ NEXT:

 Kick-down

Push the accelerator pedal fully down to achieve rapid acceleration in automatic mode. When the pedal is relaxed, normal gear changing will resume.

 Drive selector

P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console. If the engine is sw

 Drive selector fails to elevate

If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal. If the selector still fails to elevate, even if there is no obstructio

SEE MORE:

 Inner Quarter Panel

Removal NOTES: The inner quarter panel is manufactured from mild steel. There are NVH components on this panel, they are not serviced on the new panel. If damaged, new components will be required. 1. The front inner quarter panel is replaced in conjunction with: Rear bumper cover Quarter panel

 Transmission Draining and Filling

WARNING: Observe due care when draining, as the fluid can be very hot. 1. WARNING: Make sure to support the vehicle with axle stands. NOTE: Make sure that the vehicle is standing on a level surface. Raise and support the vehicle. 2. Refer to: Engine Undershield (501-02 Front End Body Panels, Remo

© 2011-2025 Copyright www.rrevoque.org