Range Rover Evoque: Garage door opener
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener
- Garage door transceiver
- Before programming
- Programming
- Rolling code device equipment programming
- Reprogramming a single garage door opener button
- To erase all programming
- Entry gate programming
- Information and assistance
READ NEXT:
Garage door transceiver
Do not use the transceiver
with any
garage door opener that lacks the
safety stop and reverse feature as
required by safety standards.
When programming the transceiver to
a garage door opener
Before programming
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best
Programming
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6
SEE MORE:
Topping up the brake/clutch fluid
Brake fluid will damage
painted
surfaces. Soak up any spillage with an
absorbent cloth immediately and wash
the area with a mixture of car shampoo
and water.
Only use new fluid from an airtight
container (fluid from open containers or
fluid previously bled from the system,
will have absor
Fuel Fired
Booster Heater Control Module (FFBHCM)
Fuel Fired Booster Heater Module (AHCM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle.
NOT
© 2011-2025 Copyright www.rrevoque.org
