Range Rover Evoque: Fuel Filter
Special Tool(s)
310-123
Locking Ring, Fuel Tank
Removal
WARNINGS:
Wait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection system.
Avoid flames, sparks or lighted substances.
CAUTION: Be prepared to collect escaping fuel.
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Fuel Tank (310-01B Fuel Tank and Lines - GTDi 2.0L Petrol, Removal and Installation).
4.
5. CAUTIONS: Extreme cleanliness must be exercised when handling these components.
Make sure that the seal is correctly positioned.
Failure to follow this instruction may result in damage to the vehicle.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
- Special Tool(s): 310-123
- Torque: 200 Nm
6.
Installation
1. To install, reverse the removal procedure.
Fuel Level Sender
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Fuel Pump and Sender Unit (310-01B Fuel Tank and Lines - GTDi 2.0L Petrol, Removal and Installation).
4.
5. NOTE: Do not disassemble further if the component is removed for access only.
Installation
1. To install, reverse the removal procedure.
Fuel Pump and Sender Unit
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Fuel Filter (310-01B Fuel Tank and Lines - GTDi 2.0L Petrol, Removal and Installation).
4.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Fuel Tank
Special Tool(s)
310-123
Locking Ring, Fuel Tank
Removal
WARNINGS:
Fuel may still be present in the fuel tank after draining.
Avoid flames, sparks or lighted substances.
CAUTIONS:
Extreme cleanliness
Fuel Tank and Lines - Diagnosis and Testing
Principles of Operation
For a detailed description of the fuel tank and lines systems, refer to the
relevant Description and Operation section in the
workshop manual. REFER to: (310-01B Fuel Tank and
Speed Control
Speed Control Actuator
Removal
1. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal
and Installation).
Installation
1. To install, reverse the removal procedure.
Speed Control Deactiv
SEE MORE:
Engine Upper/Lower Support Insulator
Engine Upper Support Insulator
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Refer to: Engine Mount RH (303-01B Engine - GTDi 2.0L Petrol,
Removal and Installation)
Air Distribution and Filtering
Component Location
NOTE: Right Hand Drive (RHD) shown, Left Hand Drive (LHD) similar
COMPONENT LOCATION
Passenger face level/side window register
Side window vent
Face level duct
Side window duct
Windshield duct
Windshield vent
Side window vent
Driver face level/side window register
Drive
