Range Rover Evoque: Speed Control
Speed Control Actuator
Removal
1. Refer to: Accelerator Pedal (310-02 Acceleration Control, Removal and Installation).
Installation
1. To install, reverse the removal procedure.
Speed Control Deactivator Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. CAUTION: LH illustration shown, RH is similar.
2.
Installation
1. To install, reverse the removal procedure.
Speed Control Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Make the air bag supplemental restraint system (SRS) safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
3. Refer to: Driver Air Bag Module (501-20B Supplemental Restraint System, Removal and Installation).
4. Torque: 1.3 Nm
5. CAUTION: Take extra care not to damage the edges of the component.
Torque: 2.1 Nm
6. NOTE: Do not disassemble further if the component is removed for access only.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Climate Control System - General Information
Climate Control
Lubricants, Fluids, Sealers and Adhesives
General Specification
Capacities
Refrigerant oil adding capacities for replacment parts
NOTE: Rotate the A/C compressor shaft at least 6 t
SEE MORE:
Wipers and Washers - Component Location, System Operation and Component
Description
Component Location
COMPONENT LOCATION - SHEET 1 OF 2
Central Junction Box (CJB)
Integrated Control Panel (ICP)
Rain/Light sensor (if fitted)
Right tailgate actuator (upper)
Rear wiper motor
Left tailgate actuator (upper)
Rear Junction Box (RJB)
Wiper control switch
Instrument Cluster (IC)
Wipers and Washers - Removal and Installation
Windshield Wiper Motor
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Plenum Chamber (412-01 Climate Control, Removal and
Installation).
2. NOTE: LHD illustration shown, RHD is similar.
Torque: 8 Nm
Installation
1. To install, reverse the removal proced
