Range Rover Evoque: Anti-Lock Control - Stability Assist
Accelerometer
Removal
NOTES:
Removal steps in this procedure may contain installation details.
LHD illustration shown, RHD is similar.
Vehicles with automatic transmission
1. Refer to: Floor Console Upper Section (501-12 Instrument Panel and
Console, Removal and Installation).
2. Torque: 9 Nm

Vehicles with manual transmission
3. Refer to: Floor Console (501-12 Instrument Panel and Console,
Removal and Installation).
4.

5.

6. Torque: 9 Nm

Installation
1. To install, reverse the removal procedure.
2. If a new component has been installed, configure using Land Rover
approved diagnostic equipment.
READ NEXT:
Component Location
Steering gear
Rubber seal assembly
Heat shield
Overview
The vehicle is fitted with EPS (electric power steering), provided by a ZF
Servolectric steering gear unit with variab
SEE MORE:
Check the tyre sidewall prior
to
inflation. If there are any cracks,
bumps or similar damage, do not
attempt to inflate the tyre. Do not
stand directly beside the tyre while
the compressor is pumping. Watch the
tyre sidewall: If any cracks, bumps or
similar damage appear, turn off the
com
Controls
1. Temperature controls. For individual
driver/passenger settings.
2. Maximum defrost program.
3. Air distribution.
Note: More than one setting may be
selected at a time to achieve the desired
distribution.
4. AUTO mode. For fully automatic operation.
5. Heated windscreen.
6. He
© 2011-2025 Copyright www.rrevoque.org
