Range Rover Evoque: Power Steering
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Steering System / Power Steering
READ NEXT:
Power Steering AWD
Component Location
Steering gear
Rubber seal assembly
Heat shield
Overview
The vehicle is fitted with EPS (electric power steering), provided by a ZF
Servolectric steering gear unit with variab
Steering Gear
Special Tool(s)
205-754A
Splitter, Ball Joints
502-012
Alignment Pins, Subframe
General Equipment
Transmission jack
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle
Power Steering FWD
Component Location
Steering gear
Rubber seal assembly
Heat shield
Overview
The vehicle is fitted with EPS (electric power steering), provided by a ZF
Servolectric steering gear unit with variab
SEE MORE:
B-Pillar Outer Panel
Removal
NOTES:
Within this procedure there are 2 different options depending on type of
vehicle body.
The b-pillar outer panel is manufactured from mild steel.
The rocker panel butt joints must be MIG brazed due to the location of boron
reinforcements.
1. The B-Pillar outer panel is replaced in
Inner Back Panel Assembly
Removal
NOTES:
The inner back panel assembly is manufactured from mild steel.
The panel is serviced less its weld studs.
The new service panel is not fully spot welded when supplied.
It is necessary to remove a section of one rear lamp mounting panel to enable
removal and installation of the inn
© 2011-2025 Copyright www.rrevoque.org
