Range Rover Evoque: Fuel Fired Booster Heater AWD

Component Location

COMPONENT LOCATION - VEHICLES WITHOUT FFBH REMOTE CONTROL

Range Rover Evoque. Auxiliary Climate Control

  1. ATC (automatic temperature control) module
  2. Fuel Fired Booster Heater (FFBH)
  3. Auxiliary coolant pump
  4. Ambient air temperature sensor
  5. Auxiliary fuel pump

COMPONENT LOCATION - VEHICLES WITH FFBH REMOTE CONTROL

Range Rover Evoque. Auxiliary Climate Control

  1. ATC module
  2. Fuel Fired Booster Heater (FFBH)
  3. Auxiliary coolant pump
  4. Ambient air temperature sensor
  5. Auxiliary fuel pump
  6. FFBH Receiver
  7. FFBH antenna matching unit

Overview

OVERVIEW

NOTE: There is no auxiliary coolant pump fitted if there is no FFBH fitted (from VIN 631090).

The Fuel Fired Booster Heater (FFBH) is rated at 5 kW and compensates for the relatively low coolant temperatures inherent in the diesel engine. The unit is located behind the RH (right-hand) front fender splash shield and heats engine coolant downstream of the heater core.

Operation of the FFBH is controlled by the ATC (automatic temperature control) module via the medium speed CAN (controller area network) bus. The operation of the FFBH is influenced by:

The FFBH will operate if the ambient air temperature is lower than 5

READ NEXT:

 Electric Booster Heater - Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Spe

 Fuel Fired Booster Heater FWD

Component Location COMPONENT LOCATION - VEHICLES WITHOUT FFBH REMOTE CONTROL ATC (automatic temperature control) module Fuel Fired Booster Heater (FFBH) Auxiliary coolant pump Ambient air temper

 Instrumentation and Warning Systems

SEE MORE:

 Balance Shaft Assembly

Special Tool(s) JLR-303-1595 Alignment Tool, Crankshaft Damper Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this procedure may contain installation detail

 Rear Wheel Bearing

Special Tool(s) 204-250 Wheel bearing install and removal tool 204-305 Remover, Wheel Bearing 204-726 Remover/Installer, Wheel Bearing JLR-204-806 Support Tool, Wheel Knuckle JLR-204-809 Installer, Rear Wheel Bearing JLR-204-810 Installer, Rear Wheel Bearing General Equipment Copper Hammer Hydrau

© 2011-2025 Copyright www.rrevoque.org