Range Rover Evoque: Instrument panel,touch screen and audio system
Do not use upholstery cleaner
on
electrical equipment such as fascia
switches.
When cleaning around electrical
equipment such as switches, ensure
that fluids do not leak into any gaps
around the components or between
panels or trim.
- Clean with a lightly moistened cloth.
- Do not use chemical agents or domestic
cleaners.
- Do not allow sharp, hard or abrasive
objects to make contact with screens.
- Avoid exposing screens to direct sunlight
for long periods.
- To prevent errors occurring, ensure that
only one finger at a time is in contact with
the touch screen.
- Do not use excessive pressure.
READ NEXT:
Fit only replacement wiper blades that are
identical to the original specification.
Before changing a wiper blade, the wiper arms
must be set in the ‘service’ position as follows;
Note: The Sm
Opening and closing the bonnet
Opening
1. Pull the bonnet release lever, located in the
left-hand front footwell.
2. Lift the bonnet safety catch lever, located
below the centre point of the bo
SEE MORE:
Special Tool(s)
412-140
Remover/Installer, Blower Motor
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
All vehicles
1. NOTE: The recirculation blend door must be closed
Control Diagram
NOTE: A = Hardwired; D = High speed CAN (controller area network) bus; O =
LIN (local interconnect network) bus
Battery
BJB (battery junction box)
Front height sensor
Rear height sensor
Headlamp leveling control module
Front right fog lamp
Front left fog lamp
Left side rep
© 2011-2025 Copyright www.rrevoque.org
