Range Rover Evoque: Rain sensor/speed sensitive wiper control
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Wipers and washers / Rain sensor/speed sensitive wiper control
Intermittent operation of the wipers is controlled initially by either vehicle speed or a rain sensor located at the upper edge of the windscreen. Both methods of control will clear the screens adequately. Vehicle speed control is set by the user and control via a rain sensor is automatic.
This function can be
enabled/disabled
by your Dealer/Authorised Repairer.
READ NEXT:
Rain sensor
Ensure that the wipers are
switched off
before entering a car wash. If the rain
sensitive wipers operate during the car
washing process, damage may occur to
the wiper mechanism.
The rain senso
Speed sensitive wipers
If vehicle speed drops below 6km/h (3.7mph)
with the wipers operating in positions (2) or
(3), the wipers will switch to the next lowest
speed. When vehicle speed increases to over
6km/h (3.7mph),
Drip wipe
If the drip wipe function is configured, the
wipers will operate four seconds after a
wash/wipe cycle has finished, to clear any
remaining drips from the windscreen.
This function can be enabled
SEE MORE:
Cooling System Draining, Filling and
Bleeding
Draining
CAUTIONS:
The engine cooling system must be maintained with the correct
concentration and type of anti-freeze solution to
prevent corrosion and frost damage. Failure to follow this instruction may
result in damage to the engine.
Engine coolant will damage the paint finished surfaces. If
Crankshaft Position (CKP)
Sensor
Special Tool(s)
303-1390A
CKP Sensor Alignment Tool
JLR-303-1595
Alignment Tool, Crankshaft Damper
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Wheel and Tire
© 2011-2025 Copyright www.rrevoque.org
