Range Rover Evoque manuals

Range Rover Evoque: Engine Mount LH/RH

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Engine - GTDi 2.0L Petrol / Engine Mount LH/RH

Engine Mount LH

Removal

NOTES:

Removal steps in this procedure may contain installation details.

Some variation in the illustrations may occur, but the essential information is always correct.

1. Disconnect the battery ground cable.

Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).

2. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

3. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).

4. Using a suitable hydraulic jack, support the transmission.

5. Refer to: Air Cleaner (303-12B Intake Air Distribution and Filtering - GTDi 2.0L Petrol, Removal and Installation).

6. Refer to: Battery Tray (414-01 Battery, Mounting and Cables, Removal and Installation).

7. Torque:

Range Rover Evoque. Engine - GTDi 2.0L Petrol

8. Torque: 175 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

Installation

1. To install, reverse the removal procedure.

Engine Mount RH

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation).

2. Refer to: Engine Cover - GTDi 2.0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).

3. Support the engine.

4. Torque: 110 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

5. NOTE: Loosen the bolt, but do not fully remove. Torque: 110 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

6. Torque: 80 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

7. Torque: 80 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

8. NOTE: Do not disassemble further if the component is removed for access only. Torque: 110 Nm

Range Rover Evoque. Engine - GTDi 2.0L Petrol

Installation

1. To install, reverse the removal procedure.

Flexplate

Removal

1. Refer to: Transmission - GTDi 2.0L Petrol (307-01 Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission, Removal).

2.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

Installation

1. CAUTION: Make sure that new bolts are installed.

NOTE: Tighten the retaining bolts in the sequence shown.

Range Rover Evoque. Engine - GTDi 2.0L Petrol

2. Refer to: Transmission - GTDi 2.0L Petrol (307-01 Automatic Transmission/Transaxle - Vehicles With: AWF21 6-Speed Automatic Transmission, Removal).

READ NEXT:

 Intake Manifold

Removal NOTES: Removal steps in this procedure may contain installation details. Some illustrations may show the engine removed for clarity. 1. WARNING: Make sure to support the vehicle with axle sta

 Oil Cooler

Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Disconnect the battery

 Oil Pan

Removal NOTES: Some illustrations may show the engine removed for clarity. Some variation in the illustrations may occur, but the essential information is always correct. Removal steps in this proc

SEE MORE:

 Engine Control Module (PCM)

Engine Control Module 2.2L - I4 - DW12c TD4  CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle.  

 Exhaust System

Exhaust System - GTDi 2.0L Petrol Lubricants, Fluids, Sealers and Adhesives * Apply to area around sensor threads prior to attempting to remove sensor General Specification Torque Specifications ** It is not appropriate to either fit or remove these fixings using air tools due to a risk of cold

© 2011-2025 Copyright www.rrevoque.org