Range Rover Evoque: Single-point/multi-point entry
When you press the unlock button, your vehicle will unlock in one of two ways: 1. Single Point Entry: Unlocks the driver's door and fuel filler flap only. A second press is required to unlock the remaining doors and the tailgate.
2. Multi-Point Entry: Unlocks all doors, fuel filler flap and the tailgate on the first press.
To change from Single to Multi-Point entry (or vise versa), press both the lock and unlock buttons simultaneously for 3 seconds. The hazard warning lamps will flash twice to confirm the change.
This feature may also be set via the settings menu. See 56, VEHICLE INFORMATION AND SETTINGS MENU.
Note: If, when the vehicle is unlocked, an audible warning is emitted, this will be a ‘Mislock’ error. There may be a fault with either of the alarm sensors. Consult with your Dealer /Authorised Repairer as soon as possible.
READ NEXT:
Global opening
Press and hold the Smart Key unlock button for
3 seconds to unlock the vehicle and open all
windows.
Press any button on the Smart Key to cancel
the operation.
Keyless entry
Keyless entry allows the vehicle to be opened if
a Smart Key is within 1.0m (3ft) of the door
handle or the tailgate external switch.
The Smart Key may not be detected if it
is placed within a me
Smart key check
If the ignition is on or the engine is running and
there is no Smart Key inside the vehicle when
the last door is closed, the message Smart Key
Not Found Refer to Handbook will be displayed
in the
SEE MORE:
Power Flows
Operation of the transmission is controlled by the TCM which electrically
activates various solenoids to control the
transmission gear selection. The sequence of solenoid activation is based on
programmed information in the TCM memory
and physical transmission operating conditions such as vehicle
Transmission Control Module (TCM), Gear Shift Module (GSM)
TRANSMISSION CONTROL MODULE (TCM)
TCM
Neutral 'N' position
Park 'P' position
Position sensor/manual shaft
Electrical connector
The TCM is located on the top of the transmission casing and is connected on
the high speed CAN (controller area network)
bus to send and receive information to and
