Range Rover Evoque: Suspending and resuming cruise control
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Cruise control / Suspending and resuming cruise control
Suspend cruise control with a single press of control (3).
To resume cruise control at the previous set speed, press control (2).
RES (2) should be used only
if the
driver is aware of the set speed and
intends to return to it.
It is not recommended to resume set
speed when a low gear is selected as
excessive engine speeds will occur.
READ NEXT:
Automatic switch off
Cruise control will switch off but the set speed
will remain in the memory when:
- The CAN button (3) is pressed.
- The brake pedal is pressed.
- Speed falls below 30km/h (18mph).
- Neutral, Park
Cruise eco data
Diesel only
When enabled, a CO2 emission indicator is
displayed in the message centre. The higher
the numeric reading, the more CO2 is being
emitted and the more fuel is being used. See
56, VEH
SEE MORE:
Before programming
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best results, fit a new battery to the
hand-held transmitter of the garage door
opener (or other devic
Programming
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6 inches) away from
the HomeLink transceiver in the rear-view
mirror, keeping the indicator lamp in
© 2011-2026 Copyright www.rrevoque.org - 0.0033
