Range Rover Evoque: Valet
Selection:
Valet mode allows the vehicle to be driven and locked by a parking attendant, without giving access to the luggage compartment. Valet mode also prevents operation of the touch screen, to prevent access to telephone numbers or navigation addresses.
From the Home menu, select Valet: Enter a memorable four digit Personal identification Number (PIN). On completion, touch the OK soft key.
If you wish to cancel the PIN, select Delete.
If the PIN is cancelled, or incorrectly entered, you will be prompted to enter the PIN again.
Valet mode activated is displayed to indicate that the PIN has been accepted.
The luggage compartment is now securely locked in Valet mode and the Valet mode On screen is displayed.
Deselection:
When you re-enter the vehicle, touch the Valet button to view the Valet mode screen.
Enter your four digit PIN and touch the OK button.
Valet mode deactivated is displayed to indicate that your PIN has been accepted.
- The luggage compartment will return to the previously set security requirement.
- The touch screen will be enabled.
Note: If the PIN is forgotten, Valet mode can only be deactivated by your Dealer/Authorised Repairer.
READ NEXT:
Extra features
There are more features available than can be
displayed at one time. This menu allows the
selected features to be displayed, for example:
- Ambient lighting: While the headlamps are
turned on, sel
Touch screen care
Do not use abrasive cleaners
on the
touch screen. For approved cleaning
products, contact your Dealer/
Authorised Repairer.
The touch screen and inner bezel must be kept
clean to maintain opti
SEE MORE:
Torque Converter, Valve Block
TORQUE CONVERTER
Torque converter housing
Lock-up clutch
Turbine
Impeller
Stator
Fluid pump
Input shaft
The torque converter is the coupling element between the engine and the
transmission and is located in the transmission
housing, on the engine side of the transmission. The driven power
Before programming
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best results, fit a new battery to the
hand-held transmitter of the garage door
opener (or other devic
