Range Rover Evoque: Voicetags
Voicetags enable the user to personalise the Voice system so that a single name can be used to call-up a navigation destination, telephone number or radio channel.
To add a Voicetag: 1. Briefly press the Voice button to start a Voice session.
2. Wait for the tone to sound then say Phone, Navigation or Radio.
3. Say Store voicetag.
Alternatively, Voicetags can be managed via the touch screen as follows.
1. Select Setup from the Home menu.
2. Select Voice from the Setup menu.
3. Select Voicetags from the Voice settings menu.
4. Select the system which the Voicetag is to activate (Phone, Navigation or Radio).
Follow the on-screen and audible instructions.
READ NEXT:
Navigation poi voice commands
To request the display of POI (Point Of Interest)
identifiers on the navigation display:
- Say Navigation, followed by the name of
the desired P.O.I category from the
following list;
- Petrol sta
Bluetooth® information
Bluetooth® is the name for
short-range radio frequency (RF)
technology that allows electronic
devices to communicate wirelessly with each
other.
The Land Rover Bluetooth® system supports
Blu
SEE MORE:
Block Heater
Removal
1. Refer to: Cooling System Partial Draining, Filling and Bleeding
(303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
2. Refer to: Engine Undershield (501-02 Front End Body Panels,
Removal and Installation).
3. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and
Installat
Torque Converter Seal GTDi 2.0L Petrol
Special Tool(s)
307-597
Installer, Torque Converter Seal
307-613
Holding Pins, Torque Converter
Removal
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
© 2011-2025 Copyright www.rrevoque.org
