Range Rover Evoque: Cooling Fan
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.
2. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
3. Refer to: Air Conditioning (A/C) System Recovery, Evacuation and Charging - GTDi 2.0L Petrol (412-00 Climate Control System - General Information, General Procedures).
4. Refer to: Condenser - GTDi 2.0L Petrol (412-01 Climate Control, Removal and Installation).
5. Torque: 5 Nm
6.
7.
8. Torque: 5 Nm
9.
10.
11. CAUTION: Take extra care not to damage the component.
12.
Installation
1. To install, reverse the removal procedure.
Coolant Expansion Tank
Removal
1. Refer to: Engine Upper Support Insulator (303-01B Engine - GTDi 2.0L Petrol, Removal and Installation).
2. CAUTION: Correct installation of the Coolant expansion tank cap can be obtained by tightening the cap until an audible click is heard.
3. Using a syringe, remove the cooling fluid from the expansion tank.
4. Torque: 10 Nm
5. NOTE: Do not disassemble further if the component is removed for access only.
Installation
1. To install, reverse the removal procedure.
Engine Coolant Level Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Coolant Expansion Tank (303-03B Engine Cooling - GTDi 2.0L Petrol, Removal and Installation).
2. NOTE: Do not disassemble further if the component is removed for access only.
Installation
1. To install, reverse the removal procedure.
READ NEXT:
Cooling System Partial Draining, Filling
and Bleeding
Draining
CAUTIONS:
The engine cooling system must be maintained with the correct
concentration and type of anti-freeze solution to
prevent corrosion and frost damage. Failure to follow this instructi
Engine Cooling - Diagnosis and Testing
Principles of Operation
For a detailed description of the cooling system, refer to the relevant
Description and Operation section in the workshop
manual. REFER to: (303-03B Engine Cooling - GTDi 2.0L
Block Heater
Removal
1. Refer to: Cooling System Partial Draining, Filling and Bleeding
(303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
2. Refer to: Engine Undershield (501-02 Front End Body Panel
SEE MORE:
Driver override options
Although Dynamic Stability Control is
automatically engaged when a special program
is selected, it can be turned off if required. See
91, DISABLING DSC.
Hill Descent Control (HDC) will be
automatically engaged for some terrain
response programs. If required it can be
deselected or engaged ind
Rear Wheelhouse Front Extension
Removal
NOTE: The rear wheelhouse front extension is taken from the rear
wheelhouse outer and is manufactured from mild steel.
1. The rear wheelhouse outer is replaced in conjunction with:
Rear bumper cover
Quarter panel
Quarter glass
Front inner quarter panel
2. For additional information r
