Range Rover Evoque: Oil Cooler
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
3. Refer to: Cooling System Partial Draining, Filling and Bleeding
(303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
4. Refer to: Engine Oil Draining and Filling (303-01B Engine - GTDi 2.0L
Petrol, General Procedures).
5. Refer to: Engine Cover - GTDi 2 0L Petrol (501-05 Interior Trim and
Ornamentation, Removal and Installation).
6.

7. CAUTION: Make sure that the area around the
component is clean and free of foreign material.
READ NEXT:
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this proc
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this proc
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Refer to: Specifications
SEE MORE:
The minimum octane rating for fuel used is 95
RON. The vehicle will run on lower ratings, but
it may cause pronounced engine knock or
pinking. If the pinking is severe it can cause
damage to the engine, fuel and emission
control systems.
Note: Occasional, light, engine knock
experienced while
Do not use abrasive cleaners
on the
touch screen. For approved cleaning
products, contact your Dealer/
Authorised Repairer.
The touch screen and inner bezel must be kept
clean to maintain optimum performance. Clean
finger marks with a soft cloth and Land Rover
approved cleaning agent. Cont
© 2011-2025 Copyright www.rrevoque.org
