Range Rover Evoque: Sand

This program should be used for

This program should be used for terrain which is predominantly soft dry sand or deep gravel.

Note: If the vehicle is unable to gain traction in extremely soft, dry sand, switching DSC off may help. DSC should be switched on again as soon as the difficulty is overcome.

If the sand to be crossed is damp/wet, and sufficiently deep to cause the wheels to sink into the surface, the Mud-Ruts program should be used.

READ NEXT:

 Wading

The maximum advisable wading depth is 500mm (19.7in). If the vehicle remains stationary in water above the door sill level, severe electrical damage may occur. Do not switch off the engine when

 Driver override options

Although Dynamic Stability Control is automatically engaged when a special program is selected, it can be turned off if required. See 91, DISABLING DSC. Hill Descent Control (HDC) will be automat

 System difficulties

Use of an incorrect program will impair the vehicle's response to the terrain and can reduce the life of the suspension and drive systems. If the system becomes partially inoperable for any re

SEE MORE:

 Locking wheel nuts

Locking wheel nuts can be removed only by using the special adapter provided in the tool kit. Note: When the vehicle is first supplied, the adapter may be stored in the glove compartment. It should be removed and stored in the tool kit as soon as possible. Note: A code number is stamped onto

 Using the touch screen

Always run the engine during prolonged use of the touch screen. Failure to do so may discharge the vehicle battery, preventing the engine from starting. Avoid spilling or splashing liquids onto the touch screen. Switching on - Switch on the ignition. - Switch on the touch screen. The mos

© 2011-2025 Copyright www.rrevoque.org