Range Rover Evoque: Garage door opener
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Garage door opener
- Garage door transceiver
- Before programming
- Programming
- Rolling code device equipment programming
- Reprogramming a single garage door opener button
- To erase all programming
- Entry gate programming
- Information and assistance
READ NEXT:
Garage door transceiver
Do not use the transceiver
with any
garage door opener that lacks the
safety stop and reverse feature as
required by safety standards.
When programming the transceiver to
a garage door opener
Before programming
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best
Programming
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6
SEE MORE:
Map split screen
Map split screen
1. TMC (Traffic Message Channel)
information.
2. North is up.
3. Small compass display which always
indicates North.
4. Next direction display.
5. Current vehicle position.
6. Vehicle direction arrow.
7. Split screen.
8. Split screen scale/zoom setting.
9. Current stree
Using wheel chocks
Note: Wheel chocks are not supplied as part of
the tool kit.
Wheel chocks are a useful addition to a vehicle
tool kit. Note the following advice when using
wheel chocks.
Before raising the vehicle,
the wheel
diagonally opposite the one to be
removed must be chocked.
Always chock the wheel
© 2011-2025 Copyright www.rrevoque.org
