Range Rover Evoque: Suspending and resuming cruise control

Suspend cruise control with a single press of control (3).

To resume cruise control at the previous set speed, press control (2).

if the RES (2) should be used only if the driver is aware of the set speed and intends to return to it.
It is not recommended to resume set speed when a low gear is selected as excessive engine speeds will occur.

READ NEXT:

 Automatic switch off

Cruise control will switch off but the set speed will remain in the memory when: - The CAN button (3) is pressed. - The brake pedal is pressed. - Speed falls below 30km/h (18mph). - Neutral, Park

 Cruise eco data

Diesel only When enabled, a CO2 emission indicator is displayed in the message centre. The higher the numeric reading, the more CO2 is being emitted and the more fuel is being used. See 56, VEH

 Stability control

SEE MORE:

 Front Seat Backrest Cover

Removal WARNINGS: To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing any air bag supplemental restraint system (SRS) components. To deplete the backup power supply energy, disconnect the battery ground cable and wait

 Power Brake Actuation

Brake Booster - Component Location COMPONENT LOCATION - 2.2L Td4 NOTE: RHD (right-hand drive) installation shown, LHD (left-hand drive) installation similar Brake booster Vacuum pipe (vehicles with stop/start system) Vacuum pump Vacuum pipe (vehicles without stop/start system) Non return val

© 2011-2025 Copyright www.rrevoque.org