Range Rover Evoque: Airbag module covers

cleaned Airbag covers should only be cleaned using a slightly dampened cloth, and a small amount of upholstery cleaner.
Any substance which enters the mechanism can prevent correct deployment of an airbag during an impact.

READ NEXT:

 Carpet and mats

Marks or stains can be removed by gentle scrubbing with a weak solution of soap and warm water. For more stubborn stains a commercially available carpet cleaner should be used.

 Instrument panel,touch screen and audio system

Do not use upholstery cleaner on electrical equipment such as fascia switches. When cleaning around electrical equipment such as switches, ensure that fluids do not leak into any gaps around

 Wiper blade replacement

Fit only replacement wiper blades that are identical to the original specification. Before changing a wiper blade, the wiper arms must be set in the ‘service’ position as follows; Note: The Sm

SEE MORE:

 Engine Mount LH/RH

Engine Mount LH Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is always correct. 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, S

 Drive Pinion Front Bearing

Special Tool(s) 100-012 Slide Hammer 205-067 Preload Gauge 308-615 Remover, Seals JLR-205-972 Mounting Bracket, Rear Axle JLR-205-984 Remover/Installer, Drive Pinion Nut JLR-205-985 Remover, Drive Pinion Bearing JLR-205-986 Installer, Drive Pinion Bearing Removal 1. Raise and support the vehicle. 2.

© 2011-2021 Copyright www.rrevoque.org