Range Rover Evoque: Standard Workshop Practices
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Description and Operation / General Information / Standard Workshop Practices
- Vehicle in Workshop
- Bolt and Nut Identification
- Pipes and Hoses
- Electrical Precautions
- Supplementary Restraint System (SRS) Precautions
- Front Airbag Deployment - Driver and Passenger
READ NEXT:
Vehicle in Workshop
When working on a vehicle in the workshop always make sure that:
Where practicable, the parking brake is applied and the wheels are
securely chocked to prevent the vehicle moving
forwards or back
Bolt and Nut Identification
An ISO metric bolt or screw made of steel and larger than 6 mm in diameter
can be identified by either of the symbols ISO
M or M embossed or indented on top of the bolt head.
In addition to marks i
Pipes and Hoses
When removing or installing flexible hydraulic pipes and hoses, make sure
that the following procedures are observed to
make sure component serviceability:
Prior to removal, clean area around hose
SEE MORE:
Jacking
General
WARNING: The
following instructions must be adhered to before raising the vehicle off the
ground:
Position vehicle on a solid, level surface.
Apply the parking brake.
Select 'P' - PARK on automatic transmission selector.
Select 'N' - Neutral on manual transmission.
WARNING: If
the
Lifting
Two-Post Lift
WARNING:
Make sure that the vehicle is stable before commencing work.
CAUTION: If
the drive shaft(s) are to be removed, release the parking brake and select
NEUTRAL 'N' in the
transmission in order that the shaft(s) can be rotated when the vehicle is
raised to the desired height.
© 2011-2026 Copyright www.rrevoque.org - 0.0058
