Control Diagram
NOTE: A = Hardwired; D = High speed CAN (controller area network) bus; O =
LIN (local interconnect network) bus
Battery
BJB (battery junction box)
Front height sensor
Rear heigh
LEFT STEERING COLUMN MULTIFUNCTION SWITCH
Off position
Side lamps position
Headlamps position
AUTO - Automatic headlamps position (if fitted)
Front fog lamps switch
Rear fog lamps switch
High
NOTE: The headlamp setting is 1.2 % below horizontal and parallel.
1. Align the headlamp beam setting equipment to one headlamp.
2. Switch the headlamps on and to dipped beam.
3. NOTE: NAS vehicles ha
Please refer to the Ownership section of the
Land Rover website at www.landrover.com,
for a list of compatible phones.
Note: The Bluetooth® equipped phones listed
on Landrover.com, have been tested for
compatibility with Land Rover vehicles.
Performance will vary, based on the phone’s
soft
Brake systems (red)
Illuminates briefly when the
ignition is switched on. If the lamp
illuminates while driving, suspect
low brake fluid level or a fault with the
Electronic Brake Distribution (EBD) system.
Stop the vehicle as soon as safety permits.
If the message CHECK BRAKE FLUID is
dis