Range Rover Evoque: Roof Sheet Metal Repairs - 5-Door
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Body and Paint / Roof Sheet Metal Repairs - 5-Door
- Roof Panel Vehicles Without: Sliding Roof Opening Panel
- Roof Front Panel Vehicles With: Sliding Roof Opening Panel
READ NEXT:
Roof Panel Vehicles Without: Sliding
Roof Opening Panel
Removal
NOTES:
The roof panel is manufactured from aluminium 6111T4.
The screw in studs must be renewed with the installation of a new roof panel.
1. The roof panel is replaced in conjunction with:
Roof Front Panel Vehicles With: Sliding
Roof Opening Panel
Removal
NOTES:
The roof front panel is manufactured from mild steel.
The 4 x screw in studs must be replaced in the installation of the roof front
panel.
1. The roof front panel is replaced in conju
SEE MORE:
Fender Apron Panel Front Reinforcement
Removal
NOTES:
The fender apron panel front reinforcement is manufactured from RP220 and
mild steel.
The panel is serviced less its weld studs
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on an
approved alignment jig.
2. The front side member and fender a
Rear Seat Cushion Cover
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Prior to carrying out the step by step procedure below, Steps 2
and 3 must be followed for knowledge on how to correctly install
and care for the seat cover.
2.
3.
4. If required, follow the steps below to carry out
© 2011-2025 Copyright www.rrevoque.org
